Video Instruction: bit.ly/nlrbuild
14
15
PARTS:
• • 4 x M8 T-Nuts
PARTS:
• • 2 x T-Nuts
16a
Install 1 x T-Nut into the side channel of the Pedal Arm. Repeat for the other side.
13
Install 2 x T-nuts into the inside channels of both Vertical Posts (Red Dots show placement).
PARTS:
• • 8 x M8 T-Nuts
15a
Install 3 x T-Nuts into the top channel and 1 x T-Nut into the side channel of the left Pedal Arm. Repeat
the same steps for the right Pedal Arm.
PARTS:
• • 4 x M8 16mm Bolts
• • 4 x M8 Washers
• • 2 x Sticky Felt Pads
(90mm x 10mm)
14a
A) Remove protective layer on the Sticky Felt strips and stick them on to the Wheel Plate to prevent scratching when adjusting.
B) Align the Wheel Plate with the T-nuts previously installed in STEP 13. Bolt through and secure with M8 Bolts and Washers.
PARTS:
• • 2 x M8 60mm Bolts
• • 2 x M8 Washers
• • 2 x M8 Flange Nuts
• • 2 x Square Washers
15b
Align the Pedal Arm with the hole on the Upright Connection Plate. Bolt through and secure with M8
Bolt, Washer, Square Washer and Flange Nut. Repeat on the other side.
Note:
Use level provided. Wheel plate
must be kept flat and level during installation
to avoid skewing.
Felt Pads
PARTS:
• • NIL
14b
Loosen bolts securing the Vertical Posts to the base. Adjust to your desired position and tighten bolts lock in place. Loosen the
bolts securing the Wheel Plate. Adjust to your desired height and angle using the alignment lines as a guide, tighten the bolts to
lock the Wheel Plate in place.
Note:
For Shorter Users Please Skip
to STEP 16a & 16b.
ADJUSTMENT RANGE
A
)
B
)
(
LEFT
)
(
RIGHT
)
TOP VIEW
SIDE VIEW
(
PRE-DRILLED HOLE
)
(
PRE-DRILLED HOLE
)
(
LEFT
)
(
RIGHT
)
(
PRE-DRILLED HOLE
)
(
PRE-DRILLED HOLE
)
ALTERNATE PEDAL INSTALLATION
(
FOR SHORTER USERS
)
