10
11
01b
Slide 8 x T-Nuts into the outside channel of the right rear member.
Video Instruction: bit.ly/nlrbuild
10
11
Note:
For easier installation hand
screw M8 bolt in to T-nut to assist
sliding T-Nut in to channel.
FRONT
BACK
IMPORTANT:
Place T-Nuts as shown in diagram below on the
OUTSIDE
of right base
(Red dots are T-Nut placement)
Note:
Slide 2 x
T-Nuts to front for
pedal support
Note:
Slide 4 x T-Nuts
to middle for wheel
post
Note:
Slide 2 x
T-Nuts to rear for
seat sliders
LEFT
RIGHT
REAR
FRONT
PARTS:
• • 4 x M8 45mm Bolts
• • 4 x M8 Washers
04
Align the threaded holes on the front and rear base extrusions with the pre-drilled holes on the left
base extrusion. Bolt through and secure with M8 Bolts and Washers.
PARTS:
• • Cable Management Clips
03
Suggested 1 x Cable Management Clip installation into the top channel of the Rear Base member.
Note:
Depress locater tab on back
side of clip to install into channel.
PARTS:
• • 4 x M8 45mm Bolts
• • 4 x M8 Washers
02
Align the threaded holes on the front and rear base extrusions with the pre-drilled holes on the right
base extrusion. Bolt through and secure with M8 Bolts and Washers.
FRONT
REAR
RIGHT
LEFT
REAR
RIGHT
