12
HOW TO INSTALL
HOW TO INSTALL
INSTALLING INTO VEHICLE
13
Locate the child restraint anchorage fitting in the
car that is directly behind seat location in the rear
seats. Refer to the car Owners Manual. If there is
no anchorage fitting then refer to pages 32 and 35
for assistance in adding an anchor fitting.
Adjust the headrest to the correct height for your
child (refer to page 11).
Position the Booster Seat in the car facing forward
in the chosen seating position.
Lengthen the upper anchorage strap by pressing
the adjuster button (1) and pulling the strap (2).
Hook the attachment clip of the Upper anchorage
Strap to the anchor fitting in the vehicle. Make sure
to remove multiple twists from the upper anchorage
strap. THIS UPPER ANCHORAGE STRAP MUST
ALWAYS BE FITTED WHEN THE CHILD RESTRAINT IS
USED IN A VEHICLE.
Pull the Upper Anchorage Adjuster Strap (3) to just
remove slack. Do not tighten causing the Booster
Seat base to lift off the vehicle seat.
Attachment Clip
Anchor Fitting
Always attach hook and remove slack.
Storage
Band
2
3
1
Note:
In some car’s, the car’s
headrest may need to be raised or
even removed to allow the Booster
Seat to sit correctly, the vehicle
headrest may also interfere with the
routing of the upper anchorage strap.
If removed, store the vehicle headrest
in a safe place but
ALWAYS refit once
the Booster Seat is no longer used.
ALWAYS
roll up excess strap tightly
and use storage band to neatly store
away from child’s reach.
Storage
Band
Roll up tightly so
the webbing is thick
enough to be held in
the storage band.