Part number:
P0450055
Release Date: January 2012
Version: 1.1
Copyright © 2011–2012 Nexsan Corporation. All Rights Reserved. Nexsan
®
, SATABeast
®
, SASBeast
™
, and the Nexsan logo are trademarks or
registered trademarks of Nexsan Corporation. All other trademarks and registered trademarks are the property of their respective owners.
Technical Support
By Phone:
U.S. & Canada
: 866.2.NEXSAN (866-263-9726) or 760.690.1111
Europe, Middle East, Africa
: +44 (0) 1332 291600
Japan
: +81 3 5449 7590
By Email: [email protected]
By Web: http://www.nexsan.com/support/service-request.aspx
NEXSAN
1445 Lawrence Drive, Thousand Oaks, CA 91320 |
p.
866.4.NEXSAN | www.nexsan.com
Safety Information
CAUTION:
When removing the SATABeast or SASBeast from the packaging, DO NOT
lift the unit by the handles on the front of the chassis. Doing so may cause damage to
the chassis or to internal components, or both. Lift the unit ONLY by the bottom edges
of the chassis, using safe lifting practices.
CAUTION:
Ensure that the ambient temperature at the installation site is between 5°C
(41°F) and 35°C (95°F). If the temperature at the site is not actively regulated, ensure
that daily and seasonal temperature changes will not result in the ambient temperature
going outside these limits.
CAUTION:
Always fully stabilize racks with wall anchors or stabilizing legs, or both,
before mounting the SATABeast/SASBeast, or any other components on the rack.
CAUTION:
Situate the rack so that full air flow at both the front and the rear of the
SATABeast/SASBeast is possible.
CAUTION:
Ensure that the floor beneath the mounting rack has enough load-bearing
capacity to support the rack and all mounted components.
CAUTION:
Always fully secure all rack-mounting hardware when installing the
SATABeast/SASBeast in a rack. Insufficient rack-mount support may allow the unit to
fall onto other rack-mounted hardware or onto the floor, potentially damaging
equipment or causing injury to nearby personnel.
CAUTION:
When applying power to the SATABeast/SASBeast, use ONLY the IEC
power cords originally supplied with the unit. Do NOT use other power cords, even if
they appear identical to the supplied cords.
CAUTION:
The SATABeast/SASBeast unit is heavy and requires two people to lift it
and slide it onto the mounting rails. Do NOT attempt to mount the unit onto the
mounting rails by yourself.
CAUTION:
Computer components and disk drives are sensitive to electrostatic
discharge (ESD). Be sure to ground any electrostatic charge from your person before
touching components with your hands or with any tools. While installing the unit, use
the anti-static wrist-strap shipped with the unit.
