Page 42/93
GEO
D
RIGGING PROCEDURE
4 push-pins (BLGEOD, 10mm diameter x 20 mm length) connect first to second GEO D10, 2 additional
push pins-are required for angle adjustment.
•
Lift bumper and top GEO D10 assembly, and position the next GEO D10 below the assembly,
with NEXO logo on the same side than the upper cabinet.
•
Lower bumper and top GEO D10 assembly carefully until the first and second GEO D10 side
rigging plates locate. Use front grid, rear vent ports or handle to guide the assembly. The rigging
plates have been designed to locate against each other and so align the holes correctly.
•
Connect the upper GEO D link bar to the lower GEO D rigging plate (or lower link bar to upper
rigging plate for “Right” configuration) by inserting one 10mm x 20 mm push-pin in the “SAFETY
PIN MUST BE FITTED” hole on each side (see figure below).
IMPORTANT
The push-pins for “SAFETY PIN MUST BE FITTED” holes must always be inserted first and
stay in position permanently. NEVER REMOVE THEM ONCE CABINETS ARE SUSPENDED.
•
Insert two additional 10mm x 20mm push-pins in the front holes (see figure above).
•
Lift the bumper and two first GEO D10’s to a height that allows convenient access to the linking
bars and the angle setting holes.
•
Insert 1 additonal push-pin to the required angle value hole on each side
•
Check that all 6 push-pins are locked.
IMPORTANT
Ensure angle settings are identical on both sides of the cabinet.
« SAFETY PIN MUST BE FITTED »
HOLE
