Page 28/93
GEO
D
RIGGING PROCEDURE
4 push-pins (BLGEOD, 10mm diameter x 20 mm length) connect first to second GEO D10, 2 additional
push pins-are required for angle adjustment.
•
Lift and position the next GEO D10 above the assembly, with NEXO logo on the same side than
the lower cabinet.
•
Lower top GEO D10 carefully until the first and second GEO D10 side rigging plates locate. Use
front grid, rear vent ports or handle to guide the assembly. The rigging plates have been
designed to locate against each other and so align the holes correctly.
•
Connect the upper GEO D link bar to the lower GEO D rigging plate (or lower link bar to upper
rigging plate for “Right” configuration) by inserting one 10mm x 20 mm push-pin in the “SAFETY
PIN MUST BE FITTED” hole on each side (see figure below).
IMPORTANT
The push-pins for “SAFETY PIN MUST BE FITTED” holes must always be inserted first and
stay in position permanently. NEVER REMOVE THEM ONCE CABINETS ARE STACKED.
•
Insert two additional 10mm x 20mm push-pins in the front holes (see figure above).
•
Lift Cabinet to release weight from linking bars and insert 1 additional push-pin per side to the
required angle;
•
Check that all 6 push-pins are locked.
IMPORTANT
Ensure angle settings are identical on both sides of the cabinet.
« SAFETY PIN MUST BE FITTED »
HOLE
