Nexcom NIO200 HAG, Руководство пользователя

Страница: 55 / 120

NIO200 HAG User Guide Page 55 of 120
7.6.3. Triggers
This section is optional and enables you to configure the trigger of a burst message. To add a Trigger
to a burst message definition:
1. In an empty edit box, type the trigger parameters in the order and format indicated in the Help
form: the burst trigger mode selection, having one of the values: Continuous, Window, Rising,
Falling, On-Change (see Cmd 104, Common Table 33), the device variable classification (see
Common Table 21 and Cmd 104), the units code (see Common Table 2 and Cmd 4), the
trigger level (float value). The command number and burst message index are the same as
those used in the burst message definition and are not editable in the interface,
2. Click Save . The trigger will be added for the selected burst message and changes will be
saved in the Monitoring Host configuration file.
To edit a trigger:
1. In the trigger edit box, edit the desired parameters and click Save . The changes will be stored
in the
Monitor_Host_Publishers.conf” file.
To delete a variable:
1. Click Delete button near the trigger edit box,
2. You will be asked for confirmation. Click Yes to delete the trigger or Cancel to abort the action.
After you perform any of the above operations, click Activate to load the changes into the Monitoring
Host.
Loading a List of Burst Message Definitions
You can add multiple burst message definitions from different devices at the same time by importing
them from a file. The file will contain the list of devices and their burst message definitions, with the
associated parameters respectively expressed as comma separated values.