Setting up the antenna
Version 2.3 - January 2009
Astra2Connect Point&Play
®
Setup Manual - page 27
Connecting the iLNB to the IPmodem
To connect the iLNB (Interactive Low Noise Block downconverter) to the IPmodem:
1
Identify the cables marked TX and RX on the coax cables (these marks are printed on the
cables every 50 cm).
2
Put the TX and RX connectors in the appropriate TX and RX jacks on the iLNB.
Make sure to use the outdoor connectors (with rubber boots) for the iLNB. The outdoor
connections need to be waterproof.
3
Put the indoor TX and RX connectors in the appropriate TX and RX jacks on the IPmodem.
The TX cable will have to be disconnected again later during the installation. Use an 11 mm
spanner to fasten the connectors on the IPmodem.
Rx
Tx
iLNB
TX
iLNB
RX
RESET
DC 15V
LAN
TX
RX
