CONEX-PSD
Two-Axis Position & Power Sensing Device
1.1.5
European Union CE Mark
Figure 3: CE Mark.
The presence of the CE Mark on Newport Corporation equipment means that it has
been designed, tested and certified as complying with all applicable European Union
(CE) regulations and recommendations.
1.2
Warnings and Cautions
The following are definitions of the Warnings, Cautions and Notes that may be used in
this manual to call attention to important information regarding personal safety, safety
and preservation of the equipment, or important tips.
WARNING
Situation has the potential to cause bodily harm or death.
CAUTION
Situation has the potential to cause damage to property or
equipment.
NOTE
Additional information the user or operator should consider.
1.3
General Warnings and Cautions
The following general safety precautions must be observed during all phases of
operation of this equipment.
Failure to comply with these precautions or with specific warnings elsewhere in this
manual violates safety standards of design, manufacture, and intended use of the
equipment.
•
Heed all warnings on the unit and in the operating instructions.
•
To prevent damage to the equipment, read the instructions in this manual.
•
Route power cords and cables where they are not likely to be damaged.
•
Keep air vents free of dirt and dust.
•
Keep liquids away from unit.
•
Do not expose equipment to excessive moisture (>85% humidity)
•
Do not operate this equipment in an explosive atmosphere.
•
Disconnect power before cleaning the CONEX-PSD unit. Do not use liquid or
aerosol cleaners.
•
Do not open the CONEX-PSD Controller. There are no user-serviceable parts
inside.
•
Return equipment to Newport Corporation for service and repair.
•
Follow precautions for static-sensitive devices when handling electronic circuits.
EDH0315En1030 — 07/16
2
