8:4
2011 Canyon Star
Class A
by Newmar
Operating the Slide Out Room (w/manual locking arms)
1.
The windows on the end of the slide out room must be closed before moving the room in either direction.
2.
Before extending or retracting the room, look for and remove any obstructions.
3.
Move the driver’s chair forward before moving the slide out room in either direction.
4.
Disengage the lock arms by pulling down on the center of the arm using the lock arm release tool, as
required.
5.
Activate the slide out switch in the desired direction to either extend or retract the room.
Please note that
you must hold the slide out switch for the duration of movement of the room
. If the switch is released
during room extension or retraction, the room will stop moving. When the room has reached full extension or
retraction, the slide out will automatically stop.
6.
If retracting the room, be sure to engage the lock arms for the slide out room as soon as it has fully retracted.
IMPORTANT
The slide out room can be stopped at any time by releasing the slide out switch. If the slide out room stops before
reaching the full “OUT” or “IN” position, the slide out controller may need adjustment. To adjust the slide out controller,
turn the adjustment screw clockwise to increase the power and counter-clockwise to decrease the power. Move the
adjustment screw in small increments. Try moving the slide out room again. Use caution. There is a potential for
component or structural damage if the screw is adjusted too high. This screw does not adjust the slide out room speed.
It sets the amount of power required to move the room against the mechanical stops.
IMPORTANT
On units equipped with
manual lock arms
, it is important to release the switch as soon it has pulled tight and stopped
moving. Current will be applied to the slide out motor as long as you hold the switch. Automatic resetting circuit
protection is incorporated to minimize the chance of failures from not releasing the button at the end of room travel, but
timely releasing of the button before the circuit protection engages is highly recommended.
MANUAL EXTENSION AND RETRACTION
The slide out room may be manually retracted. Before attempting to manually extend or retract a slide out room,
please contact your servicing dealer or call Newmar Customer Support at 1-800-731-8300.
IMPORTANT
The TRANS-TORQUE bushing must be re-tightened to re-couple the slide out gear motor before moving the coach.
This will hold the slide out room in place. The correct torque on the 11/2" TRANS-TORQUE bushing is 110 foot pounds
maximum. The correct torque on the 11/2" TRANS-TORQUE bushing of the K-900 motor (center shaft motor) is 125
foot pounds maximum.
Slide outs with either the center or end mounted motors can be moved by pushing the room the full length of its travel
in either direction. This method will require the assistance of at least two people.
Содержание Canyon Star 2011
