NewMar Canyon Star 2011, Руководство пользователя

Страница: 64 / 88

2011 Canyon Star
Class A
by Newmar
7:3
FRESH WATER SYSTEM
Kitchen Sink
The kitchen sink installed in your unit may be an acrylic, double-bowl sink equipped with two sink covers to
provide additional counter space when the sink is not in use. Cleaning care consists of washing with mild
detergents and a soft cloth. Avoid using “S.O.S.” type cleaning pads because they may scratch the surface. The
faucet in the kitchen may be a single-handle faucet with a pullout spout.
Bath Sink, Shower & Accessories
The sink in the bathroom may be a porcelain sink. Use care when cleaning to prevent from scratching the surface.
The bathroom accessories include two towel bars and a tissue holder. The faucet in the bathroom consists of a
metal body with a brass finish. The shower installed is a combination fiberglass tub/shower with a glass shower
door. The white tub faucet with shower head, hose and bracket coordinate with the sink faucet. An optional assist
handle may be installed in the tub/shower.
Monitor Panel
The monitor panel allows you to check the approximate levels in the fresh, gray, and black water holding tanks, as
well as the battery condition. The monitor panel is generally located above or near the entrance door. Simply
press the button of the item to check its status. The empty indicator light will always light when the button is
pressed. If the tank is full, all of the lights will be on. Lights are sequential and indicate the level in approximately
1/4 tank increments. For example: If the tank selected is approximately 1/2-full, then the indicator lights E, 1/4,
and 1/2 will be lit. On the right hand side of the monitor panel is the water pump switch. This switch controls the
power going to the water pump, turning it either on or off.
Monitor Panel Calibration
The monitor panel comes to you factory calibrated for accuracy and should not need to be adjusted. In the event
that the system does not read accurately, then re-calibration may be necessary. The procedure for re-calibration is
simple: First, fill the tank to be re-calibrated. Second, using the adjustment tool enclosed in the Owner’
s Package
(or any small flat-bladed screw driver), simultaneously push the button for that tank and rotate the adjustment
screw located above the button and behind the face plate counter-clockwise until some of the lights turn off in
sequence. Then slowly rotate the adjustment screw clockwise until the full light is completely on. Repeat this
procedure as necessary for the remaining tanks. The system is now calibrated properly.
Water Pump
The water pump is self-priming and totally automatic, operating on demand whenever water is required. The
water pump is used to pressurize the fresh water system when the unit is not connected to city water. The switches
to this pump may be located in the bathroom above the entrance door and in the water works compartment. To
start the pump follows these instructions:
1.
Fill or partially fill the fresh water supply tank.
2.
Open the kitchen and bathroom faucets.
3.
Turn the water pump switch on and allow the water to fill the water line and the hot water heater.
4.
Close each faucet after it delivers a steady stream of water (close the cold water first). Leave the hot water
faucets on until they also deliver a steady stream of water. This will ensure that the water heater is filled with
water.
5.
The water pump should stop running once all faucets are closed.