6
you are still unsure whether the
kegerator
has been properly installed, we
recommend that you contact a qualified installer.
Note: Allow the
kegerator
to stand in an upright position for at least 8 hours
before plugging in the unit. This is very important! Once the unit is laid on its side,
the refrigera
nt
in the refrigeration system is shifted. The refrigerant in the
refrigeration system needs to stabilize before the unit is turned on.
Installing the Casters
Follow the steps below to install the casters.
Empty the inside of the cabinet completely and lay the
kegerator
down on its side.
We recommend that you place a piece of cardboard or cloth underneath
the cabinet to prevent dents or scratches.
1.
Note: Two of the casters include locking
mechanisms to ensure the unit does not
slide on hard floors. These two locking
casters should be fastened at the front
end of the unit, with the unlocked casters
fastened on the rear end.
2.
3.
Insert the casters into the holes on the bottom corners of the cabinet. Tighten
each caster by turning the head of the bolts clockwise with a wrench. (
N
ot
provided in the kit
.
)
Once all four casters have been
tightened, stand the cabinet in its
upright position.
Installing the Beer Tap
Follow the steps below to install the beer tap.
There are notches on the bottom of the draft arm
assembly that line up with grooves inside the
opening on the top of the kegerator. Align
simply lock it into place.U
s11 &12
)
Beer
Dispenser
Tower
Beer Duct
Guard Rail
ASSEMBLY INSTRUCTIONS
the draft
arm with the opening on the top of the unit, then
place inside and twist until secure. No screws are
black gasket for assembly. (See Illustrations C &
D on page
)
necessary,
se the thin
