New Leader Guardian L3030G4 MultApplier, Руководство оператора

Страница: 86 / 88

86
Determining Driving Centers
Once an acceptable pattern is obtained, as shown in Figure 12, driving centers can be determined. To
determine optimum driving centers (effective swath width), determine the average amount of material
in the center of the pattern. Figure 13 shows an example data sheet recorded from the pro fi le shown in
Figure 14. Based on the example, the average amount of material in the center of the pattern is 3.0, as
indicated with the red dotted line.
Next, locate the points on both the left and right side of the pattern where the amount of material is half
the average amount at the center of the pattern. In the example shown in Figure 13, these points are
located 45’ to the left of center, and 45’ to the right of center. The distance between these two points
(90’) represents the driving centers to use.
NOTE: Once the effective swath width has been established, a change in the controller may be required.
313964-A
Temperature:
°F
lbs/acre
Spinner Speed:
RPM
Controller Vehicle Speed:
MPH
Controller Swath Width:
10’ 15’ 20’ 25’ 30’ 35’
40’ 45’ 50’ 55’
-0- 10’ 15’ 20’ 25’ 30’ 35’
40’ 45’ 50’ 55’
1
2
3
4
5
6
7
1
2
3
4
5
6
7
60’ 60’
3.5 3.0 3.0 3.03.0 3.0 3.0 2.5 2.5 2.5 2.5 2.5 1.50.5 2.5 2.5 2.0 1.5 0.5
ACCEPTABLE PATTERN
Average amount of
material in the center
ŽĨƚŚĞƉĂƩĞƌŶсϯ
&&d/s^td,t/d,͗ϰϱ͛нϰϱ͛сϵϬ͛
45’ 45’
WŽŝŶƚƐǁŚĞƌĞŵĂƚĞƌŝĂůŝƐŚĂůĨŽĨƚŚĞĐĞŶƚĞƌŽĨƚŚĞƉĂƩĞƌŶсϭ͘ϱ
Figure 13 - Effective Swath Width
Figure 14
80’ 80’ 90’ 90’ 100’ 100’
www.NewLeader.com
(800) 363-1771
307369-AA-G
L3030G4 CNH
Header Spread Pattern