New Leader Guardian L3030G4 MultApplier, Руководство оператора

Страница: 58 / 88

- 58 -
www.NewLeader.com
(800) 363-1771
307369-AA-G
L3030G4 CNH
Header
#4 CONVEYOR CHAIN - BIN 2
Hose down unit and remove any material build-up on sprockets and under chain.
NOTICE!
The conveyor will move away from the bottom panel if material accumulates under the conveyor or on
the sprockets. The more material that accumulates, the closer the chain will come to the chain shields.
If the conveyor should catch a chain shield, it could permanently damage the conveyor, the chain
shields or the unit. Do not remove material while conveyor or spinner is running!
Lubrication
Make sure unit is clean and completely dry. Lubricate insert conveyor chain at the end of each week or after
40 hours of operation, which ever occurs fi rst.
Shut down spinner and run conveyor at 20 RPM for two full revolutions to lubricate chain. After each unit
washing, allow to dry, then lubricate each chain strand at rear of unit using a pressurized garden sprayer.
Refer to “Lubricant & Hydraulic Oil Speci fi cations” for recommended lubricants.
Tension
Figure 11 - Proper chain tension is also a factor in chain and sprocket life. Measure from rear of unit forward
to achieve proper chain tension. Make sure chain is tensioned equally on both sides. This adjustment is
made on each side of the unit at the idler bearings.
Chain Tension to be Measured
from Rear of Sill.
Proper Tension:
MULTAPPLIER Conveyor
30” to 34”
(76cm - 86cm)
REAR OF INSERT
30” - 34” (76 cm - 86cm)
Figure 11 - Chain Tension
Conveyor chains that are too tight will tend to stretch, causing excess sprocket wear and eventually breakage.
Excess slack presents the possibility of chain catching on sub-frame parts. Bent or distorted chain bars will
cause damage as well. Straighten or replace bent or distorted chain bars immediately.
Lubrication & Maintenance