New Leader Guardian L3030G4 MultApplier, Руководство оператора

Страница: 67 / 88

- 67 -
L3030G4 CNH
www.NewLeader.com
(800) 363-1771 307369-AA-G
Header
IMPORTANT! Do not operate or work on machine without reading and understanding the operator’s manual.
Before starting engine/before starting machine operation
Program rate controller and document settings Hydraulic hoses are secured properly
All stop, tail, and turn lights function properly Gearcase oil level is correct
Tire pressures are equal on each side of chassis Safety shields in place
Battery condition and connection Spinner Assy moves through full range of operation
Electrical connections are tight and secure Spinner discs and fi ns installed properly
All fasteners are secure Spinner discs and fi ns are in acceptable condition
Inverted “V” is secure and installed properly Material Divider assembly is square and secure
Sensor(s) are functioning properly Material Divider is clean of build-up
Lubricate all grease fi ttings Feedgate assembly is level
Hydraulic oil level and line connections are tight Encoder installed and secured
Hydraulic fi lters are current and gauge is functional Spinner sensor adjusted to proper gap
Chain oiler tank is full and operates correctly
Start engine/Start and run to operational temperatures
Hydraulic fi ttings are tight, no leaks * Conveyor control valve is operating correctly
Check operation of all alarms Calibrate radar/ground speed input
Hydraulic fl ow test: ____GPM @ operating engine RPM Test maximum conveyor(s) RPM
Check main relief valve setting :_____ PSI
Test right and left hand spinner speed; ensure
difference is less than 30 RPM (when at operating
RPM)
Stop operation/Turn off engine and engage parking brake
Visually check for leaks All oil levels full
Check belt/chain tension and alignment
Perform Calibrations
Product density testing, crush strength, and SGN scale (See Spread Pattern Calibration section for instructions).
Catch tests of all products and at least 1 blend for conveyor calibration and document settings and product
characteristics
Spread pattern tests of all products and at least 1 blend and document settings and product characteristics
End of Season
Empty unit of all material Clean unit inside and out
Sand and touch-up paint as necessary Check for leaks
Wash chain conveyor, lubricate thoroughly when dry Lubricate all grease fi ttings
Check spinner discs and fi ns for wear Ensure all fasteners are secure and properly
toruqed
Pre- & Post-Season Checklists