New Holland 715648006, Руководство оператора

Страница: 8 / 16

8
12. Pull down on the cable jacket to remove slack and
secure the cable to the handle using three cable clips,
three 1/4 x 1 in. bolts, and three 1/4-20 in. locknuts
(Fig. 12).
Installing the Steering Stops
1. Align a steering spindle stop in front of the rear tabs
on each front wheel spindle so that the stops contact
the axle during tight turns and prevent the wheels from
contacting the blade frame (Fig. 15).
2. Secure the stops with two 5/16 x 3/4 in. (19 mm) self
tapping bolts (Fig. 15).
1471
1
2
3
4
Figure 15
1. Steering spindle stop
2. Self tapping bolt,
5/16 x 3/4 in. (19 mm)
3. Rear tab
4. Tire
Removing the Blade
Note: Save all hardware, rods, washers and hairpin cotters
for future use.
1. Park the machine on a level surface, set the parking
brake, stop the engine, and remove the ignition key.
2. Raise the attachment lift to the transport position.
3. Turn the Dial-A-Height knob counterclockwise, all the
way.
4. Lower the attachment lift lever to the mounting
position; refer to Lowering Attachments.
5. Remove the hairpin cotter and washer from the
trunnion at the lift plate (Fig. 16).
1265
2
4
3
5
1
Figure 16
1. Hairpin cotter
2. Washer
3. Trunnion
4. Lift plate
5. Hairpin cotter–from mower
6. Remove the hairpin cotter and slide lift plate off of the
attachment lift (Fig. 16).
7. Remove the hairpin cotters and clevis pins from the
latch levers (Fig. 17).
1470
2 4
1
3
Figure 17
1. Clevis pin
2. Hairpin cotter
3. Latch lever
4. Frame
8. Open the latch levers and lower the frame (Fig. 17).
9. Push in on the front hitch release button to open the
hitch and remove the blade lift arm (Fig. 18).