New Holland 715648006, Руководство оператора

Страница: 7 / 16

7
m-5070
2
3
4
7
5
8
11
9
10
9, 10, & 11
1
6
Figure 12
1. Control handle
2. Release lever
3. Z-fitting on the cable
4. Pivot support
5. Handle pivot bolt
6. Jam nut, 1/2 in.
7. Control rod
8. Large hairpin cotter
9. Cable clips
10. Locknut, 1/4-20 in.
11. Bolt, 1/4 x 1 in.
2. Install the 1/2 in. jam nut on the pivot bolt to lock it in
place (Fig. 12).
3. Rotate the control handle to align the hole at the
bottom of the handle with the control rod (Fig. 12).
4. Insert the control rod through the handle end and
secure it with a large hairpin cotter (Fig. 12).
5. Connect the Z-fitting on the end of the cable to the
release lever (Fig. 12).
6. Thread the balled end of the cable through the keyhole
slot in the frame up to the fitting on the cable jacket.
7. Slide the fitting through the slot and push it to the
right, ensuring there is a jam nut on each side of the
frame (Fig. 13).
m05040 & 5041
1
2
3
6
7
5
6
7
4
Figure 13
1. Rear view
2. Front view
3. Cable jacket
4. Cable
5. Fitting
6. Keyhole slot
7. Jam nuts
8. Tighten the jam nuts.
9. Insert the balled end of the cable into the cable
bracket.
m–5043
1
2
3
4
1
4
Figure 14
1. Cable bracket
2. Cable
3. Angle pin
4. Cotter pin, 1-1/4 in.
10. Attach the cable bracket to the angle pin at the blade
assembly (Fig. 14) with a 1-1/4 in. cotter pin.
Note: Put the cotter pin through the hole that removes the
most slack from the cable.
11. Bend the ends of the cotter pin.