New Cosmos Electric XP-3000II Series, Инструкция по эксплуатации

Страница: 7 / 80

3
1.
Introduction
Thank you for purchasing the New Cosmos XP-3000II series portable gas detector. Prior to
use, please read this instruction manual carefully to ensure safe and reliable operation.
XP-3000II series has single-gas (1-gas) and two-gas (2-gas) models available. 1-gas
models measure one combustible gas or oxygen, while 2-gas models simultaneously
measure one combustible gas and oxygen. The detector simultaneously displays one or two
gas concentrations. When gas concentrations reach a preset level, the detector alerts the
user via audible and visual alarms, thus, helping prevent incidents such as low oxygen, gas
poisoning and explosion. This detector uses an intrinsically safe structure.
Carefully read this manual, regardless of your experience with gas detectors. Do not use the
detector for any purposes other than those intended or described in this manual.
Symbols Used in this Manual
This manual uses Danger, Warning, Caution and Note symbols to draw attention to
procedures, materials, methods, and processes, which require particular attention.
Indicates an imminently hazardous situation that can result in death
or serious injury.
Indicates a potentially hazardous situation that may result in death
or serious injury.
Indicates a hazardous situation that may result in minor injury or
property damage.
Provides information on product handling.
DANGER
WARNING
CAUTION
NOTE
Waterproof
Keep the gas detection ports dry.
This detector employs a waterproof structure, which meets the New
Cosmos-specified submersion test* compliant with IEC60529 ingress
protection code IPX7 in the new condition to prevent malfunctions due
to water entry during normal usage. However, if the filter element is
wet, proper gas detection is not possible. Gaskets or sealing
deteriorated by age, or adhesion of foreign materials will impair the
waterproof function; thus, exposure to water should be avoided as
much as possible.
*Submersion test procedure:
Submerge a brand new detector into room temperature tap water to
a depth of 1 meter for 30 minutes. Verify that water is not present
inside the detector.
WARNING