New Buck Corporation 61TV, Руководство по установке

Страница: 8 / 21

8
PREPARING LOG KIT
1. Open the cartons containing the Burner Base and the logs. Inside one of the cartons you
will find the Burner Base. The logs are boxed separately and numbered as follows:
Front (1)
Rear (2)
Right Side Top (3)
Left Side Top (4)
WARNING: POSITIONING OF THE LOGS IS VERY CRITICAL. (See Figure 3.)
(A) POSITION THE REAR LOG #2 IN REAR LOG HOLDERS, CENTERING LEFT TO
RIGHT.
(B) PLACE FRONT LOG #1 OVER FRONT TUBE OF BURNER, CENTERING LEFT TO
RIGHT OVER BURNER TUBE. YOU WILL NOTICE THE FRONT AND REAR LOGS
HAVE PINS EXTENDING FROM THEM.
(C) TAKE RIGHT TOP LOG #3 AND PLACE IT OVER THE PINS LOCATED AT THE
RIGHT SIDE OF THE FRONT AND REAR LOGS, FACING THE BURNER BASE.
(D) PLACE LEFT LOG #4 OVER THE PINS OF THE LEFT FRONT AND REAR LOGS.
(E) WHEN IGNITING THE BURNER, CHECK AND MAKE SURE THE FLAME IS NOT
TOUCHING EITHER SIDE OF LOG #3 OR LOG #4. IF FLAME IS TOUCHING LOGS ON
EITHER SIDE, MOVE SLIGHTLY TO THE LEFT OR RIGHT TO ELIMINATE THE
FLAME FROM TOUCHING EITHER LOG.
Figure 5
2. Close and latch door.
LIGHTING AND SHUTDOWN
NOTE: Prior to lighting, check all fittings for leakage. This is accomplished by applying soapy
water on all connections made. If there is any leakage bubbles will appear at the point of
connections. If bubbles occur, tighten the fittings until the bubbles no longer appear. All
connections made at the factory have been previously tested.