13
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A
FIRE OR EXPLOSION MAY RESULT CAUSING PROPERTY DAMAGE,
PERSONAL INJURY OR LOSS OF LIFE.
A. This appliance has a pilot which must be lighted
by hand. When lighting the pilot, follow these
instructions exactly.
B.
BEFORE LIGHTING:
Smell around the
appliance for gas. Be sure to smell next to the floor
because gas is heavier than air and will settle on the
floor.
WHAT TO DO IF YOU SMELL GAS
♦
Do not try to light any appliance.
♦
Do not touch any electrical switch; do not use
any phone in your building.
♦
Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
♦
If you cannot reach your gas supplier, call your local
fire department.
C. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don’t try to repair it, call a qualified service
technician or gas supplier. Force or attempted repair may
result in a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician to
inspect the appliance and to replace any part of the
control system and any gas control which has been under
water.
1.
STOP!
Read the safety information above.
2.
Make sure the manual shutoff valve is fully open.
3.
Turn off all electrical equipment.
4.
Open access panel door.
5.
Turn control knob clockwise to the “OFF” position.
NOTE:
Knob cannot be turned from “PILOT” to “OFF” unless knob
is pushed in slightly. Do not force
.
6.
Wait (5) five minutes to clear out any gas. Then smell for gas,
including near the floor. If you smell gas,
STOP!
See page 3,
in the safety information. If you don’t smell gas, proceed to the
next step.
IN
ON
OF
F
P
IL
O
T
VENT
HI
LO
7.
Remove the pilot access panel located below and behind the gas
control unit.
8.
Find pilot - follow metal tube from gas control. The pilot is
between the two burner tubes behind the pilot access panel.
9.
Turn knob on gas control counter clockwise to “PILOT”.
10. Push in control knob all the way and hold in. Immediately light the
pilot with the Piezo button. Continue to hold the control knob in for
about one (1) minute after the pilot is lit. Release knob and it will
pop back up. Pilot should remain lit. If it goes out, repeat steps 5
through 10.
*If knob does not pop up when released, stop and
immediately call your service technician or gas
supplier.
*If the pilot will not stay lit after several tries, turn
the gas control knob to “OFF” and call your
service technician or gas supplier.
11. Turn gas control knob counterclockwise to “ON”.
12. Close control access panel.
13. Turn on all electric power to the appliance.
14. Set thermostat to desired position.
TO TURN OFF GAS TO APPLIANCE
1. Set the thermostat to lowest setting.
2. Turn off all electrical power to the appliance if
service is to be performed.
3. Remove control access panel.
4. Push in gas control knob slightly and turn
clockwise to “OFF”. Do not force.
5. Replace control access panel.
LIGHTING INSTRUCTIONS
Содержание 61TV
Страница 2: ...2...
