NEW BRUNSWICK SCIENTIFIC BioFlo 4500, Руководство по эксплуатации

Страница: 73 / 214

New Brunswick Scientific Co., Inc. User’s Guide
73
9
9
M
M
L
L
-
-
6
6
1
1
0
0
0
0
C
C
O
O
N
N
T
T
R
R
O
O
L
L
L
L
O
O
O
O
P
P
O
O
P
P
E
E
R
R
A
A
T
T
I
I
O
O
N
N
S
S
NOTE:
The following procedures refer only to the use of the BioFlo 4500
equipped with the ML-6100 controller .
9.1 Adding a New Loop to the Display
Adding a new signal input (feedback signal) and control output (control signal)
will require that the controller be “configured” for the new loop through the
touchscreen interface.
Users of
BioCommand Supervisory Software should note that only the first ten
control loops of the controller communicate with BioCommand . For example, if
your application requires 16 control loops on the controller, only the first ten
configured control loops will be available in
BioCommand . This limitation is
within NBS digital protocols, and does not limit the capacity of the controller to
accommodate its full complement of 16 control loops.
To add a new loop to the display:
1. Select the
CONFIG BUTTON
in the
GAUGE SCREEN
. A
MAIN
CONFIGURATION SCREEN
box will appear.
2. Select
ADD
. You will be prompted for the
SYSTEM CONFIGURATION
PASSWORD
.
3. Enter the configuration password and press
OK
. The default
SYSTEM
CONFIGURATION
PASSWORD
is
NBS
. If the
SYSTEM CONFIGURATION
PASSWORD
was set to blank, you will not be prompted for a password.
4. The
ADD NEW LOOP PROMPT
will appear.