Neuation iFUGE L400P, Руководство пользователя

Страница: 9 / 16

Press PRG button to select the program from 1-99.
9
PRG
The different parameters can be set in each program
for quick selection.
10
Quick Spin
Press hold for immediate centrifugation up to last set
RPM
9. OPERATING THE CENTRIFUGE
SWITCH ON THE CENTRIFUGE
After connecting the power cord. Switch ON the main power supply & then Switch
on the power switch located on the right side of the instrument. Make sure to
check the rotorfitment before use. Centrifuge will not operate with open lid.
Note: Maintain a gap of 3 seconds between switch OFF and switch ON again. 00 NOTswitch OFF
and ON again instantly.
Speed Setting:
Press RPM/RCF button to set speed from 500 to 4500 RPM. Single press to set
speed, long press to toggle mode RPM/RCF. The parameter can be set when the
speed screen blinks by using + button for increment & "- "button for decrement.
The values will automatically saves after screen stops blinking.
Timer Setting:
Press the timer button to set timer. Time can be set by + for increment & - for
decrement. The timer will save automatically once the blinking stops. The timer
can be set in minutes only while seconds are for countdown timer for running
operation.
Acc/Dcc:
This button will set the parameters of acceleration or deceleration of the rotor
ramp. Press acc/dcc button once to set the acceleration from 1-9 by using +/­
button for increment/decrement respectively. Similarly press once again the
acc/dcc button to set deceleration from 1-9 by using
+/-
button for
increment/decrement respectively. The values of accelaeration & deceleration
timings are listed below.
Ace 1 dcc 1
180
Seconds
Ace 6 dcc 6
90
Seconds
Ace 2 dcc 2
170
Seconds
Ace 1 dcc 1
70
Seconds
Ace 3 dcc 3
150
Seconds
Ace 8 dcc 8
50
Seconds
Ace '-1 dcc Y
130
Seconds
Ace 9 dcc 9
30
Seconds
Ace S dcc S
110
Seconds
11