NetterVibration NTP 18, Руководство по эксплуатации

Страница: 13 / 21

Installation
13
Netter Vibration
recom-
mends mounting the NTP on
a weld-on console. Weld the
weld-on console to the on-
site mounting surface so that
the vibration energy is opti-
mally distributed.
NTP on weld-on console
2. Observe the recommended values for screw size and tightening tor-
ques.
3. If necessary, additionally use a medium-strength liquid safety agent to
secure the screw connections.
4. Observe the recommended cross-sections for valves and hoses. For
the air supply, preferably use screw connections with integrated seals
or a liquid sealant. Avoid sealing tape. Do not use longer screw-in
threads for the air supply than intended (e.g. no pipes with external
thread). Otherwise the housing may be deformed and the piston there-
by jammed.
5. Fasten the compressed air supply securely.
The air resistance increases with the hose length. The nominal diameters
in Ch. Technical data, from page 7 on, apply to hose lengths up to 3 m.
Longer supply lines require larger cross-sections.
If necessary, the escaping air is diverted through a hose, which must be
installed as follows:
1. Remove the silencer.
2. Fasten the exhaust air hose directly to the exhaust air connection.
3. Mount the silencer at the free end of the exhaust hose.
If the NTP is to achieve full performance, then the exhaust hose must have
a larger nominal size than the supply hose.
Air supply
Air discharge
line