NetterVibration NTP 18, Руководство по эксплуатации, Страница: 7 / 21

Technical data
7
3 Technical data
Drive
medium NTP must be operated with clean, lubricated compressed air or lubricated
nitrogen according to the following specification:
ISO 8573-1 [ 5 : 6 : 4 ]
Filter ≤ 5 µm
Humidity,
Pressure dew point ≤ +3 °C
Total oil content
≤ 5 mg/m
3
NTP L versions are suitable for operation with oil-free, dried com-
pressed air according to the following specification:
ISO 8573-1 [ 5
:
6
:
2 ]
Lubrication ISO viscosity class according to DIN ISO 3448, VG 5 to 15
Fill the mist lubricator with acid- and resin-free compressed air oil.
Recommendation for temperatures
from 0 to 60 °C:
Klüber "AIRPRESS 15"
Specification for temperatures
above 60 °C with HT designs:
Aral „Farolin“
Specification for temperatures from
0 to -20 °C:
Klüber "ISOFLEX PDP 10"
Specification for temperatures
below -20 °C for NT versions:
BREAK FREE
®
CLP
Ambient
temperature* Standard and NTP L versions: 5 °C to 60 °C
NT versions:
-32 °C to 60 °C
HT versions:
5 °C to 160 °C, depending on ver-
sion
Operating
pressure* 2,0 to 6,0 bar
* Higher operating pressures and temperatures are only permitted after consultation with and the written con-
sent of application engineers from
Netter Vibration
.
IMPORTANT
NTP B + C may only be operated clocked.
A duty time of max. 60 s must be followed by a pause of at least 60 s. Al-
ternatively, with a short duty time (≤ 12 s) a pause factor of 5 may be used
(e.g.: duty time 5 s - pause time 25 s).
Permissible
operating
conditions
Clocked
operation