NETGEAR GS716Tv2 - ProSafe Gigabit Managed Switch, Руководство администратора, Страница: 66 / 246

GS716Tv2 and GS724Tv3 Software Administration Manual
3-2 Configuring Switching Information
v1.0, July 2009
Figure 3-1
Table 3-1. Port Configuration Fields
Field Description
Port Select the port from the menu to display or configure data for that port. If
you select
All , the changes you make to the Port Configuration page
apply to all physical ports on the system.
Description Enter the description string to be attached to a port. The string can be up
to 64 characters in length.
Port Type For most ports this field is blank. Otherwise, the possible values are:
•
MON: Indicates that the port is a monitoring port. For additional
information about port monitoring see Chapter 6, “Monitoring the
System” .
• LAG: Indicates that the port is a member of a Link Aggregation trunk.
For more information see “LAG Membership” on page 3-7 .
Admin Mode Use the menu to select the port control administration state, which can
be one of the following:
•
Enable: The port can participate in the network (default).
• Disable: The port is administratively down and does not participate in
the network.
Port Speed Use the menu to select the port’s speed and duplex mode. If you select
Auto , the duplex mode and speed will be set by the auto-negotiation
process. The port’s maximum capability (full duplex and 1000 Mbps) will
be advertised. Otherwise, your selection will determine the port’s duplex
mode and transmission rate. The factory default is
Auto .