NetBotz wallbotz 500, Руководство пользователя

Страница: 62 / 80

55
Installing Hardware Options
After you have installed the Power Control Pod, use the Basic
View or the Advanced View
Output Control task to complete your
installation.
Note: If, after you have installed and configured a Power Control Pod,
you later choose to uninstall the pod, replace it with a different
serial device, or move the pod to a different serial port, you must
perform a simple uninstall procedure using the Advanced View
Serial devices task before connecting a new serial device to the
previously used serial port. Failure to follow this procedure will
result in your appliance becoming unstable. For more
information, see “Reassigning Serial Ports” on page 63.
Configuring and Installing a Power
Control Pod 110 or 230
To configure and install your Power Control Pod 110 or 230:
1. Connect your USB-to-serial port adapter to your WallBotz
500 base station, or to a USB hub that is connected to the
WallBotz 500 base station.
Notes: The serial port connector on the USB-to-serial port
converter cable is a male connector. You will need to use
a female-to-female connector null modem cable
(included with your Power Control Pod) to connect the
device to the USB-to-serial port adapter.
You cannot connect a Power Control Pod to the
WallBotz 500 integrated serial port. This port is
designated for appliance configuration and diagnostic
use only.
2. Ensure that the Power Control Pod is set to address 0. To
set the pod address, turn the rotary switch labeled ADRS ,
located on the back of the pod, until the small arrow is
pointing at the number 0.