NetBotz wallbotz 500, Руководство пользователя

Страница: 54 / 80

47
Installing Your Appliance
2. Measure the distance between the WallBotz 500 base
station and the location at which you will install the pod. You
will need to connect the pod to the base station using a USB
cable, and depending on the distance between the pod and
the base station you might require USB extender cables or
(because the Camera Pod 120 is a high-power USB device) a
powered USB hub.
3. Place the Camera Pod 120 at the installation location. The
pod can be mounted to a wall using the included wall mount
bracket, if desired, or you can mount it using standard camera
mounting hardware.
4. Connect the Door Switch Sensor to the Camera Pod 120.
5. Connect the Camera Pod 120 to a USB Port on your
WallBotz 500 appliance.
Due to bandwidth requirements, you should avoid
connecting more than one Camera Pod 120 to a single
USB Port. Connecting multiple Camera Pod 120s to a
single USB port will dramatically lower the maximum
frame rate available from all cameras sharing the port.
For best performance, connect only a single Camera Pod
120 to each USB port.
USB Ports A and B share bandwidth. Connecting
Camera Pod 120s to both USB Ports A and B will
dramatically lower the maximum frame rate available
from both cameras. For maximum performance, connect
only one Camera Pod 120s to USB Port A or USB Port
B. Note that USB Ports C and D do
not share
bandwidth: You can connect one Camera Pod 120 to
each of these ports without impacting their performance.
Shortly after the Camera Pod 120 is connected to a USB Port on
the base station the LED on the Camera Pod 120 will illuminate
to indicate that it has been recognized by the base station and is
now functional.
Installing an Undocked Sensor Pod
120
To install and tether an undocked Sensor Pod 120: