NetBotz wallbotz 500, Руководство пользователя

Страница: 51 / 80

44
Installing Your Appliance
c.
Using another adhesive strip, mount the non-wired
portion of the switch to the door. Be sure to mount the
second piece of the switch so that when the door is
closed the two portions of the switch are as close to each
other as possible.
Note: Once both pieces of the door switch are mounted, there must be
no more than 1/4” of space between the two pieces when the
door is closed.
2. Mount the WallBotz 500 to your wall.
If you will be mounting the WallBotz using the
included black universal swivel wall mount:
a.
Select a location for the wall mount, and then use the
included WallBotz swivel wall mount template to mark
the locations in which the anchors need to be installed.
b.
Install the screw anchors. Then, use the screws
included with the wall mount to secure the wall mount to
your wall. Be sure to use the included wall anchors and to
tighten the screws enough to ensure that the appliance
will be securely fastened to the wall.
Do not overtighten
the screws.
c.
Using the bracket mount on the rear of the WallBotz,
connect the WallBotz to the wall mount by screwing the
WallBotz onto the wall mount until it is snug.
d.
Use the swivel points on the wall mount to orient the
WallBotz so that it is pointed in the desired direction.
When facing the bracket, you can rotate the appliance
clockwise and counter-clockwise by turning the entire
appliance; the post will rotate with the appliance. To
swivel the appliance vertically, turn the knob on the
bracket just below the point at which the appliance
connects to the bracket, adjust the position of the
appliance as desired, and then tighten the knob again.
If you will be mounting the WallBotz flush against
your wall: