NetApp FAS2500, Замена

Страница: 25 / 26

XII.
Step
9
10
Wait for the "Waiting for Giveback.." message text to be displayed again.
11
12
a) IF Cluster-Mode: Confirm the "giveback" status of the storage, refer this doc > ONTAP 8 failover show
NOTE
13 If Cluster-Mode, follow steps (a-b) below otherwise skip to Step 14.
a)
Example of output here>
net int show
b)
An example of issuing the "net int revert" command is here.
14
a)
15
If the "giveback" is incomplete, wait 2 minutes and re-check. If still not complete after 10 minutes, contact Support .
Do not proceed to next step if 'incomplete or partial giveback'!
At the clustershell prompt, enter the command below to list the logical interfaces that are not on their home node and port.
If any interfaces are listed as "false" in the above command, engage customer to revert those interfaces back to their
home port using the '
net int revert'
command.
Move console cable to the TARGET node if not already connected and enter the appropriate command to display the ONTAP
version running.
Go to section XIII, "Send Autosupport, Enable Options, Submit logs, Part Return" on the next page.
Verify the version displayed is the same as the ONTAP version captured in section IV. Issues? Call

NGS.
Page 24 of 25
FAS2500 Model : Boot the Operating System - 'giveback' if applicable (cont.)
Action Description
Move console cable to the PARTNER node if not already connected and enter the proper controller giveback command(s) based
on the mode running as follows:
Wait! 90 seconds for 7-Mode or 3 minutes for Cluster-Mode after giveback reported complete.
Check controller failover status by entering the appropriate command shown for the specified ONTAP Mode.
Move console cable to the TARGET node if not already connected and observe the console logs. The TARGET node takes back
its storage, completes booting up into the login prompt, and then reboots and is again taken over by the PARTNER node.
Boot Device Replacement for the FAS2500
For NetApp Authorized Service Engineers
7-Mode
target> version
Cluster-Mode
cluster::> run local version
7-Mode
partner(takeover)> cf giveback
Cluster-Mode
cluster::> storage failover giveback -fromnode local
......
......
login:
ontap_varfs: Rebooting to load the new varfs
Abandoned in-memory /var file system.
Terminated
.
Uptime: 4m1s
System rebooting...
......
......
......
Waiting for giveback...(Press Ctrl-C to abort wait)
Waiting for giveback...(Press Ctrl-C to abort wait)
System will be rebooted up to
"Waiting for giveback...." if HA or "login"
Do NOT Press Ctrl-C during the boot process!
NOTE:
The TARGET node takes back its storage,
completes booting up into the login
prompt, and then reboots to load the
new varfs and is again taken over by the
PARTNER node.
Cluster-Mode
cluster::> storage failover show
7-Mode
partner> cf status
Controller Failover enabled,
Node-02 is up. Follow step (a)
Look for failover enabled
ONTAP 8 C-Mode in clustershell
cluster::> net int show -is-home false