IX.
Step
C. Start the Netboot Process (cont.)
3
Read the below Table and follow the correct Action:
Table-3
Check which procedure to be followed from the two options below:
i.
Follow
Non
-Disruptive Procedure
- Go to Sec X.
ii.
Follow
Disruptive Procedure
- Go to Sec XI.
"HA" system and the TARGET node was
successfully taken over by its PARTNER
TARGET node does not have a partner (non-HA)
OR the PARTNER did not takeover.
Page 17 of 25
FAS2500 Model : Prepare and Start the Netboot Process (cont.)
Action Description
Do you want to restore the backup configuration
now? {y|n}
After the installation of the ONTAP software, the following question will be displayed to select your option about restoring
the 'varfs' backup configuration
Do
NOT
answer to this question now! - The correct response to this question depends on which
procedure will be followed in Table-3.
S
T
O
P
......
......
Extracting to /cfcard/x86_64/freebsd/image2...
Installed MD5 checksums pass
Installing diagnostic and firmware files
Firmware MD5 checksums pass
Terminated
Installation complete.
**************************************************************
* Restore Backup Configuration *
* This procedure only applies to storage controllers that *
* are configured as an HA pair. *
* *
* Choose Yes to restore the 'varfs' backup configuration *
* from a SSH server. Refer to the Boot Device Replacement *
* guide for more details. *
* Choose No to skip the back up recovery and return to the *
* boot menu. *
**************************************************************
Do you want to restore the backup configuration
now? {y|n}
WAIT
for this message to be displayed
- Do
NOT
answer it before reading
Table-3
below.
The correct response to this question depends on which procedure will be followed in Table-3.
Boot Device Replacement for the FAS2500
For NetApp Authorized Service Engineers
