Instruc�on Manual 08/2020
17 of 24
5. CLEANING & MAINTENANCE
WARNING: DO NOT CLEAN A STOVE
WHILE HOT.
Always keep the area around the unit clean and clear
of furniture and other objects. Keep all furniture and
drapery a minimum of one metre from the stove.
Clean the stoves surface using light strokes of a real
bristle paint brush. Stoves with a cast black finish
should never be cleaned with a cloth as the texture
of the paint will abrade and collect lint from the
cloth which will be almost impossible to remove.
Stoves with an enamel finish should be cleaned with
a damp cloth, or very gentle use of a cleaner
recommended for enamel finishes. In case of
condensa�on, clean the affected areas before they
dry.
Inspect the en�re unit frequently for proper
operation, fit and soundness of parts. If any
malfunctioning, cracked, broken, or loose parts or
other problems are noted, contact your dealer or
qualified serviceman to inspect and repair the unit.
DO NOT OPERATE THE UNIT IF INSTALLED OR
FUNCTIONING IMPROPERLY.
Seals
Check the fit and seal of the doors and ash pan
door frequently. For proper opera�on an air�ght
seal must be maintained around these openings. If
the seal is not �ght, inspect the gasket. If the gasket
needs replacement, contact your dealer. If the gasket
is in good condi�on, check the closure latch screws;
if these are loose, adjust the door handle (Fig. 23).
Glass
Your stove is fi�ed with 4 mm ceramic glass. Properly
operated, your glass door will not get coated with
thick tar like conventional stoves. If this does
occur, you may have to resort to using a glass cleaner.
However, by using dry wood, much of the tar on the
glass will burn clean, when the appliance is run at
high temperature.
Clean the ceramic glass when cold, using commercial
products sold for this purpose, or warm water with
a drop of vinegar.
The glass used in your stove is not toughened glass
but ceramic, which can only be broken due to a
strong blow or a bad use. Inspect the glass regularly.
If it is damaged, replace the glass using a new glass
seal kit immediately.
WARNING: Replacement of damaged glass must be
done with original parts supplied by your dealer.
Use of other materials could cause a safety hazard
and void your warranty.
CAUTION: NEVER OPERATE YOUR STOVE WITH
BROKEN GLASS.
Replacement of the glass:
1. Open the door. L i f t o ff t h e stove s b o d y.
2. Remove the 4 fixing screws and remove the glass
and old seals.
3. Replace the seals and glass.
4. Install the 4 screws. Do not over �ghten the screws.
Note: When replacing glass, always replace glass
seals
Any maintenance or adjustment, not described in
this manual, must be performed by a trained and
competent technical service engineer.
Door handle adjustment (see Fig. 23)
The stove is equipped with an adjustable door latch.
For correct operation, the stove door must be
air�ght when closed.
To adjust the door handle latch:
1.
Loosen the locking nut.
2.
Adjust the bolt in or out as required.
The adjustment should be made in such away
that when the handle is in its closed position
the door is air�ght and the handle ver�cal.
3.
Re-�ghten the locking nut.