13
To Disarm
to disarm the system.
Touch
+
When you enter the protected
premises through a delay zone,
the keypad responds with regular
beeps
1
as a reminder to disarm.
If the panel is not disarmed by the
end of the entry delay time, an
alarm will occur.
Using the optional radio keys,
you may disarm your system from
inside your premises or from just
outside.
2
If you make a mistake when
entering your user code, press”E”
and start again. five incorrect
entries will cause an alarm.
The panel can be reset and the
siren/s silenced by disarming the
panel.
If you arrive at your premises and
find the strobe light flashing
3
reset
the panel as above. To check the
cause of the alarm, you can view
the alarms in memory by entering
Memory Mode.
arM onlY codes
User codes can optionally be
programmed to be arm only
codes. an arm only code can arm
the system but it cannot disarm.
however if an arm only code is
assigned to a radio key, the radio
key off button will arm and
disarm.
1
If Entry Beeps are enabled.
2
The strobe light will flash to
indicate arming and disarming by
radio key. your installer can also
enable siren ‘Chirps’ for an audible
indication of radio key operation.
3
In the event of an alarm, the
strobe light will flash for 72 hours or
until the panel is reset.
aUto re-arM
your panel may be programmed for auto re-
arm to help prevent accidental disarming.
auto re-arm checks that you have entered the
premises after disarming. If all zones remain
sealed for a period as set by the entry delay
time then the panel will re-arm. This is most
useful when used with radio keys where the
off button might be accidentally pressed after
you have armed and are leaving the premises.
A valid user code.
