5000 Series Dialler
Page 6
DIALLER #1 and #2 REPORTING.
P35E option E
0 =
Do not use the Primary and Secondary telephone numbers at all
(ie. only the Extra number can be used).
1 =
Alternate calls between Primary and Secondary telephone numbers
if no Acknowledge tone is received. Note: if no Acknowledge tone
is received for either number, then no transmission will be made.
2 =
Use Primary number for half of the calls and then if no
Acknowledge tone is received, use the Secondary number for
the remainder of the calls.
3 =
Transmit to the Primary number and when complete, REPEAT all the
data to the Secondary number. Note: this will only occur a successful if
transmission was made to the Primary telephone number within 5 calls.
Only one of the above options is allowed and the default is 1.
4 =
Allow the Extra telephone number to be used
5 =
Disable the Test (Status) Reports when the Dialler Auto-Answers (see P44E).
Options 4 and 5 may be chosen in addition to the other options.
DIALLER #1 and #2 TRANSMISSION FORMAT.
P36E option E
1 =
If no acknowledge tone is received, transmit in the NESS Audible format.
2 =
If transmitting in Low Speed format, old alarms which are
still active are to be included in the transmission.
3 =
If a high speed acknowledge tone is received, transmit using
the Ademco Extended format.
4 =
Invert 8/9 for Open/Close in Low speed format.
5 =
If an acknowledge tone is received from a 'beeper' type pocket pager system
do not transmit any alarm reports.
None, one or all of the above options may be chosen and the default is none.
The Dialler always transmits in the format identified by the
Acknowledge tone but this may be modified by the above.
