Page 5
3.
Configure all your wireless zones
in the "Wireless
Expander" and then 'send' the data to the M1 System.
From within Installation program mode select menu 14 “Wireless Definition”.
Press RIGHT arrow key to select this menu. Press UP or DOWN arrow
keys to select menu 3 “Learn Wireless Transmitter”.
Press RIGHT arrow key to enter learn mode. Either enter the zone number
you wish to program in or use the UP or DOWN arrow key to scroll to the
zone you wish to enter. Once the correct zone number is selected press the
RIGHT arrow key to enter LEARN mode.
Go to the transmitter and activate it to send the ‘learn signal’ to the RF
Receiver (re below of how to send a learn signal for each device). The
keypad should emit a short tone when the transmitter becomes enrolled.
If the M1 voice is enabled (not available on M1 EZ8 systems), the system will
provide voice prompts and feedback of enrolment. If the voice prompt speaks
"Press Transmitter button for ..." If the zone prompt does not speak a Voice
description then it is will be because you have not entered one in for the Zone
being enroled.
Once enrolled the system will automatically move to learn mode of the next
zone.
If a zone has already been enrolled and an attempt is made to enrol it again
into another zone an error will be annunciated.
LEARNING IN DEVICES INTO THE M1
SENDING A "LEARN SIGNAL"
Radio Key
RK3 (3 Button) & RK4 (4 Button)
Radio PIR & RR1
R12, R15, R15 Pet
& RR1 Reed Switch
Radio Reed Switch
(Model RR1)
Press both On and Off
Buttons at the same time
Connect the battery
Activate the
Tamper
Switch
Radio Buttons
Press & Hold the button
Wireless
Smoke Detector
Connect the battery
then press and hold Test
button for approx 10-20
seconds until it learns in.
Wireless
Keypad
Press both *
panic buttons
