N e p t u n e
™
1 . 2 5 H P P o o l P u m p M o t o r
I n s t a l l a t i o n a n d O p e r a t i o n M a n u a l
8
Installation Instructions
Follow these instructions to prolong the life of the pump motor and control. Install the product on a
secure and level platform or base, such as a concrete pad.
Installation, operation, and maintenance must be performed by qualified personnel. Familiarization with
and adherence to the National Electrical Code (NEC), National Fire Protection Association (NFPA)
standards and to local codes are required. It is important to observe safety precautions to protect
personnel from possible injury.
·
Code requirements differ from state to state. Install equipment using qualified electricians in
accordance with the applicable codes and ordinances in your area and in accordance with NEC. All
electrical connections should be made and maintained by a qualified or licensed electrician.
Protect against Heat
·
Shade the motor / control from the sun.
·
Provide ample cross ventilation.
·
Protect the motor / control from lint, etc., which can clog the ventilation openings.
Protect against Dirt
·
Keep the motor / control and the surrounding area clean.
·
Avoid sweeping or stirring dust near the motor / control while it is running.
·
Avoid storing or spilling dry chemicals near the motor / control.
Protect against Moisture
·
Provide protection from rain, snow, etc.
·
Do not
wrap the motor / control with plastic or other air tight materials.
·
Locate the motor / control on a slight elevation so that water does not run or puddle nearby.
·
Avoid splashing water on or near the motor / control.
·
Repair leaky pipe joints or pump seals promptly.
Preparing the Motor for Operation
The Neptune
™
1.25HP has been functionally tested before shipment. Most pool installations already
have the electrical power in conduit. However, on-site installation requirements and electrical codes vary
widely and are the responsibility of the installer. The motor / control must be wired before operating.
Note
: An electrical power cable is
not
provided.
You will need the following tools.
·
1/4 socket or nut driver
·
Flathead or Phillips screwdriver
