Nuvo-6000 Series User’s Manual
Copyright © 2016 Neousys Technology Inc. All Right Reserved.
Page 69 of 100
3.9 Connect DC power to you Nuvo-6000
Nuvo-6000 series uses a 3-pin pluggable terminal block to accept 8~35V DC power input. It
provides the reliable way for directly wiring the DC power. To supply DC power via the 3-pin
pluggable terminal block, please follow the steps described below.
1. Make sure the external DC power supply is power off or disconnected before wiring.
2. Get the 3-pin pluggable terminal block from the accessory box. The terminal block fits
the wires with a gauge of 12~24 AWG.
3. Carefully identify the positive and negative contacts of your DC power supply and
pluggable terminal block. The polarities between DC power supply and terminal block
must be positive (+) to positive (+) and ground (GND) to ground (GND).
4. Insert the wires to correct contacts of pluggable terminal block and tighten clamping
screws using a Philips screwdriver.
5. Firmly plug the terminal block into a receptacle on the front panel, and tighten the
captive screws using a Slotted screwdriver.
Caution
1.
Nuvo-6000 series accepts 8~35 VDC when using terminal block for DC input. Please make
sure the voltage and polarity of DC power is correct before you connect it to Nuvo-6000
controller. Supplying a voltage over 35V or incorrect polarity will damage the system.
V+ GND