29
ENGLISH
3. If necessary, press the Up or Down button to adjust the address position.
Each key stroke brings the address 1 mm (0.04 inch) with a maximum of 12 mm
(0.48 inch) lower or higher.
If the required address position is beyond the maximum range of 24 mm (0.96 inch),
the Fill & Start function can not be used. Use a programmed job instead.
4. Press
to make another test run.
5. Recheck the position of the address, and adjust as required.
6. Press
to leave this screen to return to the “main menu (1)” or press the
button to immediately start the job.
Starting the Job
To start a job:
1. Press the
button to start the job.
During running the display shows the “inserting” menu.
2. Press the
button to stop the job. The machine will stop immediately.
3. Press the
button to clear the document path to prepare the machine for a new
job.
When a Fill & Start job is defined successfully these settings can be stored into a job. Use
the copy function in the job menu (see 3.11 ”Copy a Job” on page 40) to store the
settings.
3.7.2
Select Another Job
To select another job:
1. Press
to select another
predefined job.
2. Press the arrows to select another job number.
The screen shows the job options of the relevant
job (see 2.4.2 ”Job Info” on page 12).
3. Press
to confirm the selected job.
