24
The document separation for
special feeders
must
be adjusted manually as follows:
1. Push the knob
B
forward until it clicks.
2. Open the left-hand side guide
A
by turning it
downwards.
3. Place a document on the feed tray and slide it
about 60 mm (2.4 inch) into the system (turn
the knob
B
counter clockwise if the separation is
set to narrow).
4. Push the document between the separation
rollers, which are behind the rubber paper
pullers.
5. Turn the knob
B
clockwise to get more
resistance or counter clockwise to lower the
resistance.
The separation is adjusted correctly when a slight resistance is felt on the document.
6. Pull the knob
B
back again when ready.
7. Close the left-hand side guide.
3.4.4
Filling the Document Feed Tray
Fill the document feed tray as follows:
1. Open the left-hand side guide A by turning it downwards.
The feed rollers will automatically be lifted.
2. Place a stack of documents between the side guides.
3. Turn the left side guide upwards again.
4. Feed the documents (depending on the type of documents and the type of fold) as
shown in 3.4.1 ”Document Orientation” on page 22.
3.4.5
Adjustment of the Document Stoppers
The document stoppers mark the position at which the documents coming from the feeder
turn towards the folding area. The position of the document stoppers is automatically
determined by the system during the job programming.
A
B
