18
•
The document directly beneath this document must be at least 60 mm (2.4 inch)
longer than the BRE.
•
The upper document must be longer than the set address fold.
•
The folding mode is either single fold or letter fold (no Z-fold).
•
The upper document must be shorter than the envelope height.
Note
It is possible to use the BRE offset for a BRE and an enclosure (card) in one set. The extra
condition is that this enclosure is equal to or smaller than the set address fold and should
be placed direct underneath the BRE in the set.
The whole BRE offset is based on friction between documents within a set. Therefore it is
necessary to make use of these conditions to reduce the risk of bad transporting, folding
and inserting.
Flap Closer
When selecting from the “supervisor menu”
,
, the “flap closer”
menu appears. Use this function to improve the
envelope sealing process for a job. The offset can be
varied between -20 and 20. If for example the offset
is set to +10 the sealing process will be activated 10
pulses later than initially.
For each of the jobs 1 through 25 and F&S (Fill &
Start) an offset can be set.
Test
The “test menu” menu can be opened from the
“supervisor menu”. Use this menu to check the
system, reset all photocells and execute an OMR
test. The menu consists of the following functions:
•
: use this function to check if all
motors, clutches and sensors are correctly
connected. This test derives the status of the
actuators and clutches by briefly activating the
actuators and then measuring the current.
Note
Remove all paper and close all covers before testing.
•
: use this function to calibrate all photocells.
