42
To configure or modify the settings of the Push Button, click on the corresponding "Edit" button in the
Peripherals page. A new page appears, allowing you to set all the parameters of the connected Push
Buttons.
ID:
The ePowerSwitch 8M+
R2
automatically creates an ID Code to clearly identify each Push button.
•
PB followed by a number identifies each Push button
Name:
In this field, enter the name you want to give to the selected Push button. The name can be from 1 to 32
characters long, and can contain alphanumeric characters.
Do not use quotes or special characters in labels!
Activated
This check box must be checked to activate the push button and enables to deactivate it temporarily while
keeping all its settings for a later use.
Digital Inputs
Sensor ID:
The ePowerSwitch 8M+
R2
automatically creates an ID Code to clearly identify each action.
•
SP1 identifies each "Short Push" action (during less than 1 second)
•
LP2 identifies each "Long Push" action (during more than 3 seconds)
Create new rule:
Click on this button to create a new rule.
Name:
In these fields enter the name of the two type of action (Short Push or Long Push).
Do not use quotes or special characters in labels!
LOGOUT:
Click "Logout" at the bottom of the page to exit the session without saving changes.
DISCARD CHANGES:
Click "Discard Changes" at the bottom of the page to discard all the changes you have made on this page.
APPLY CHANGES:
Click "Apply Changes" at the bottom of the page to save changes.
