Neodrives Z20 RS, Руководство пользователя

Страница: 17 / 26

32 33
0
4
|
B
AT
TE
R
Y
0
4
|
B
AT
TE
R
Y
0 4 | B AT T E R Y
04. 2 | SWITCHING ON
THE BAT TERY
SET TING THE BAT TERY TO "DEEP SLEEP " MODE
Keep the battery button pressed for more than 5 seconds:
The LEDs shut down one after the other 5-4-3-2-1-0. When the
last LED has extinguished, keep the battery button pressed for
another 2-3 seconds. Within the next 60 seconds, the battery
goes into "Deep sleep" mode.
INFORMATION:
The battery is automatically set to "Deep
sleep" mode if not used (LCD switched off, battery button
not pressed). In this state, the standby power consumption is
reduced to a minimum, to allow prolonged storage periods
without a great loss of capacity, for example.
WAKING THE BAT TERY FROM "DEEP SLEEP "
After switching off the S-Pedelec and removing the charging
plug, the battery goes into "Deep sleep" mode to reduce the
standby power to a minimum. Press the battery button briefly
to wake the battery up again. All 5 LEDs will light up, followed
by a brief pause after which all LEDs will flash briefly three
times. The battery is now operational again.
Only use the battery charger provided to charge the battery.
Using an unsuitable battery charger may lead to malfunctions
and reduce the battery's service life. There is also a risk that it
may catch fire or explode.
Connect the plug on the battery charger to the mains first
before connecting the battery.
0 4.1 | BAT TERY LED DISPL AY/
BAT TERY BUT TON
The position of the battery and therefore the visibility of the
battery button depends on the model. It can be located on the
top or bottom side of the down tube. You can use the battery
button on the top of the battery to call up the following infor-
mation or carry out the following actions:
01.
Switching on the battery
02.
Check the battery's state of charge
03.
Setting the battery to "Deep sleep" mode
04.
Waking the battery from "Deep sleep"
To ensure the display functions correctly, it may be necessary
to disconnect the battery from the system beforehand (unplug
the battery or remove it from its frame).
The battery UR V8 RS need not be wakened by pressing the
battery button. Pressing the ON/Off button on the neoRemo-
te Z20 RS is sufficient (siehe Seite 18). The system powers
up after a few seconds (5 seconds), the light switches on and
the start screen appears.
CHECKING THE CURRENT STATE OF CHARGE
Press the battery button briefly: the battery's state of charge
will be displayed
(State of Charge)
• 5 LEDs lit: battery has 80-100% charge.
• 4 LEDs lit: battery has 60-80% charge.
• 3 LEDs lit: battery has 40-60% charge.
• 2 LEDs lit: battery has 20-40% charge.
• 1 LED lit: battery has 0-20% charge.
• 1 flashing LED: battery is flat.