NeoDen NeoDen10, Руководство пользователя

Страница: 56 / 64

56
(1)Front fixed buckle
(2)Material-sendingwheel gear
(3)Press material cover
(4)Locking Claw
(5)Tail board
（6）
Single-track wheel
（7）
Hand Shank
（8）
Tape coiling wheel
（9）
Cylinder
（10）
Snap joint cover
13.2 Installing tape and reel components
figure 1 figure 2
1. Making the feeder in open status to wait for installing the tape reel
①
Lift up the feeder fixing handle
； ②
Press
the material-sending handle with left hand
③
meanwhile press the lamellule at right side of the feeder with your
right hand ；
④
loosen the material-sending handle, ensure the proper wrapped (see figure 1) then loosen the
lamellule.
2. Installing the tape and reel components: setting the reel on reel storage at the back side of the feeder, pull out
approximately 10cm length tape, separate the film and tape, then put into transfer storage (see figure 1).The tape
should be closely matched with the gear, and the film should pass through the upper denomination groove (see
figure 2) through two white guide wheels and then be sandwiched between two gears.