NeoDen NeoDen10, Руководство пользователя

Страница: 37 / 64

37

Footprint/ Value: Component footprint/ value. Footprint refers to the footprint name like 0603, 0805, 1206 etc., Value
refers to component data like 10K, 75Ω etc

Pick Height
：
the height between nozzle and taps&reel’s surface on feeder.
How to check pick height: Go to the Batch processing pick up position and height interface,enter the
thickness of the component, click nozzle down (if the feeder is closed,after click nozzle down, the feeder
will open),then manually check if the nozzle could reach the component.Adjustment can be applied according
to the test.
Go to XY movement interface, select Nozzle #1-#8, please lock the position and enter a pick height before clicking Pick test
to check if the pick height is appropriate. P.S.when you doing pick test in the interface of Batch processing pick up position
and height, the feeder won’t open automatically,please select the upper component to do pick height test.

Pick delay: For special components like large IC and large capacitor, it’s better to set some long
time on the pick delay to make sure nozzle can pick up them stably.
⚫
Place delay: For special components like large IC and large capacitor, it’s better to set some long time on the place
delay to make sure nozzle can still suck the component stably during the movement to place on the board.
⚫
Move speed: It is used to control the head movement speed, generally just keep default will be ok. It is need be changed
slower while doing some pick test.
⚫
Down speed: It is used to control the nozzle head Z-axis downward speed (Special notice: for lead pitch distance<
0.5mm, please set this to a lower speed).
⚫
Vision : Against component to choose applicable vision method.
For resistor/ capacitor--- please select Flying calibration.
For component which doesn’t require higher precision but higher speed,you can select No action.
For IC, you can select IC correction or big IC correction according to different IC sizes. The difference is that IC correction
is one shot recognition; big IC correction is separately taking photos for IC’s four corners. So, if the IC size more than
35mm, please directly select big IC correction method.

Accuracy: Generally normal resistor/ capacitor is default as high speed mode, do not need to modify it; For IC, please
select high accuracy mode.

Brightness:
it refers to the brightness of component recognition (after be picked up) in assembly procedure. The same
footprint’s brightness varies in different machines, so we can’t provide a recommended brightness.During setup, please
use size measurement function to adjust the brightness until the components are well recognized.