MR-YK – HIGH VIBRATION YOKE INSTALLATION (Ordered Separately)
Refer to alternate instructions if using Conduit, Hook, Pole, Wall Mount, or Yoke Mount
STEP 1.
Inspect shipping package and contents to ensure no damage has
occurred during shipping. Discard surface/ceiling mounting bracket
provided with MR luminaire.
STEP 2.
Mount MR high vibration yoke to mounting surface using a minimum
of 4x ¼-20 or M6 fasteners (not provided).
STEP 3.
Install suitable wiring system to the conduit opening per CEC/NEC
requirements for the speci-fic location of install.
NOTE:
To aid in assembly and protection against ingress use of a petrolatum or soap
thickened mineral oil based thread lubricant/sealant is necessary.
Un-used conduit opening must be plugged to maintain the integrity of the
enclosure.
STEP 4.
Mount MR Cheek Plates to sides of MR luminaire using 4x M6 flat head
cap screws per side. Thread one cheek plate over installed wiring
during assembly. Torque fasteners to 5 Nm (45 in-lbs).
STEP 5.
Thread installed wiring through opening in MR high vibration yoke
mount and install MR luminaire into yoke. The raised circular bosses on
the MR cheek plates should register inside of the large circular holes on
the MR high vibration yoke mount arms. Rotate luminaire to aim in the
desired direction and fasten in place using 2x M6 socket head cap
screws and flat washers per side. Torque fasteners to 5 Nm (45 in-lbs).
STEP 6.
Resume installation instructions provided with luminaire. (STEP 4 in MR
Installation Instructions provided with Luminaire)
Step 4
Step 2
This MR-YK kit is intended for use with UL Listed MR luminaire as
marked on the luminaire nameplate.
Accessory Package Contents
INSTALLATION STEPS
MR-YK
PART NAME
QTY
1
2
8
4
4
MR HIGH VIBRATION YOKE
CHEEK PLATE
M6 x 1 x 25mm SOCKET FLAT HEAD CAP SCREW
M6 FLAT WASHER
M6 x 1 x 16mm SOCKET HEAD CAP SCREW
TM
Nemalux
I N D U S T R I A L
MR-GEN
rev. A-15
1-1
www.nemalux.com | [email protected] | Tel 403•242•7475 | Fax 403•243•6190
MADE IN CANADA
WARNING:
The MR Head must not face upwards
by any degree beyond the vertical
position for Class II, Division 2, Zone 22,
and Class III hazardous locations.
LIGHT BEAM
HORIZON
4.3in
3.8in
108mm
95mm
2.3in
59mm
10 x 7mm 0.3in THRU ALL
8.0in
203mm
3.1in
80mm
