Nelson NCD+ Auto-Gap Gun, Инструкция по эксплуатации и техническому обслуживанию

Страница: 12 / 29

© 2016 Nelson Stud Welding, Inc. Page 12
All Rights Reserved. February 2016 Part No. 729-110-042 v1.03
3.2 Setting Up Foot and Leg Assembly
The NCD+ guns come supplied with a foot and spark shield ( Figure 3.2a Spark shield Foot & Leg Assembly ). The
foot is installed on the end of the legs. Alignment of the foot is important. The chuck should be located in the
center of the spark shield. To install the foot, unscrew the leg screws and place them through the holes in the foot.
Reattach the leg screws to the legs. Maintain concentricity between the chuck and spark shield.
Figure 3.2a Spark shield Foot & Leg Assembly
Also included with the foot & leg assembly are three locating pins used to make the tripod setup. The spark shield
and the locating pins may be used together or independently during welding operations.
Figure 3.3b Tripod Foot & Leg Assembly
*See section 7 for part numbers