Genesis Manual Rev2.0 Copyright 2020, Nellis Engineering, Inc.
5
Assembly
Before diving the DPV for the first time, the
body of the DPV must be connected to the
tail section. Review the
Warp Core User
Manual
to ensure the battery is properly
assembled. Lower the battery into the DPV
body with the cable from the nose of the
DPV body on the side of the battery with
the Charge Control circuit board. Stop 3 to
4 inches before the tube opening and
connect the cable to the white 4 pin
connector (Figure 1). Rotate the 2 black
locking bars clear of the notches in the red
aluminum plate (Figure 2) and finish
lowering the battery into the DPV body so
the gray bars align with the notches in the
red plate of the battery. Rotate the black
lock bars into the slot in the gray bars to
lock the battery in place and install the two
red thumb screws finger tight (Figure 3) .
Figure 1
THUMB SCREWS
Figure 3
LOCK BARS
Figure 2
CABLE
FROM DPV
NOSE
