NEFF V6540X2, Инструкция по эксплуатации и руководство по установке

Страница: 23 / 56

Positioning and connecting
en
23
■
The earthing system is properly
installed.
■
The mains cable is only replaced by
a qualified electrician (if this is
necessary). Replacement mains
cables are available from the after-
sales service.
■
No multiple plugs/couplings or
extension cables are used.
■
If an earth-leakage circuit breaker is
used, only a type which displays this
symbol is used:
z
.
Only this symbol guarantees
compliance with the currently
applicable regulations.
■
The mains plug can be accessed at
all times.
■
The mains cable is not bent,
squashed, modified, cut through, or
in contact with heat sources.
Before washing for the first
time
The appliance was inspected
thoroughly before leaving the factory. To
remove any residual test water, run
Cottons 60°C programme the first time
without laundry.
Note:
■
The appliance must have been
installed and connected properly.
~
"Positioning and connecting"
on page 14
■
Never switch on a damaged
appliance.
1.
Insert mains plug.
2.
Turn the water tap on.
3.
Close the door. Do not load any
laundry.
4.
Select theCottons 60°C programme.
5.
Open the detergent drawer.
6.
Add standard detergent to
dispenser
II
according
to manufacturer’s instructions for
light soiling.
Note:
To prevent over sudsing, use
only half the recommended amount
of detergent. Do not use any
woollens or mild detergents.
7.
Close the detergent drawer.
8.
Select
I
(Start/Pause).
9.
When the programme ends, turn the
dial to the Off position and open the
door.
Your appliance is now ready for use.
Transportation
e.g. when moving home
Preparatory work:
1.
Turn off the water tap.
2.
Reduce the water pressure in the
supply hose.
~
Page 44
3.
Drain any residual water.
~
Page 43
4.
Disconnect the appliance from the
mains.
5.
Remove the hoses.
6.
Empty the dispensers.
~
"Detergent drawer and housing"
on page 42
Installing the transport locks:
1.
Remove the covers and keep them
in a safe place.
Note:
Use a screwdriver if
necessary.
2.
Insert all four sleeves.
a) Clip the mains cable securely in
the holders.
b) Insert and tighten the screws.
c) Clip the hoses securely in the
holders.
Before switching on the appliance
again:
Note:
The transport bolts must be
removed.