UPASS ACCESS | INSTALLATION GUIDE
Reader Configuration
16/23
Figure 12: Output message format
The output message format is configurable:
<prefix> [<tagstatus>] [<epclen>] [<epc>] [<datlen>] [<data>] <suffix> [ CR/LF ]
5.3.3
EXTRA OUTPUT
Optionally enable Wiegand or magstripe output for tags that are not programmed by
Nedap in a Wiegand, magstripe or nedap-xs format. This feature is introduced in
firmware version 2.13 or newer.
'Protocol':
Disabled
Do not use the additional output feature.
Wiegand
Enable additional Wiegand output.
Magstripe
Enable additional magstripe output.
'Data source':
EPC number
Output the EPC number using the selected protocol.
Custom read data Output the custom data read using the selected protocol.
See for more information about how to setup custom read
data chapter 5.2.1.
'Alignment':
Full
Use the complete EPC number (or all custom read data).
Left
Truncate data. Keep left.
Right
Truncate data. Keep right.
'Data length':
Data length in bits for Wiegand (or in digits for magstripe).
'Offset':
Data offset in bits for Wiegand (or in digits for magstripe).
'Add constant':
Enable to add a constant to the output before or after the
data read from the tag.
