Necta StarFood, Инструкция по установке, эксплуатации и обслуживанию

Страница: 29 / 64

25
© by NECTA VENDING SOLUTIONS SpA 0110 171-01
Some models are fitted with drums that have shaped
dividers (available also as accessories for later installa-
tion) so that rectangular shape products can be accom-
modated (see Fig. 16).
In this case the number of compartments cannot be
changed.
Fig. 17
1 - Shaft
2 - Shaft supports
3 - Hexagon head screws
COOLING SYSTEM
The cooling unit is mounted onto the base.
The cooling temperature, between 0° C and 3° C, is preset
by the manufacturer.
Fig. 18
1 - Stack of magnets
2 - Drive cog wheel
3 - Drum sliding guide
4 - Rear evaporator
5 - Compressor
6 - Central ventilation
7 - Condenser
8 - Front evaporator
9 - Temperature sensor
AUTOMATIC DEFROSTING DEVICE
Automatic defrosting is enabled through programming.
The defrosting system operation, indicated in Fig. 19, is as
follows:
The bypass solenoid valve stays open until the sensor on
the evaporator detects a temperature of 4° C.
However, the software ensures that the defrosting cycle
does not exceed 10 minutes.
Fig. 16
1 - Upper half-disk
2 - Lower half-disk
3 - Right-hand shaped divider
4 - Left-hand shaped divider
DISASSEMBLING THE DRUM STACK
Because of the dimension of the stack two persons are
necessary to remove the entire drum stack easily.
- Remove the upper drum.
- Undo the 2 hexagon head screws of the drum shaft
support.
- Remove the external shaft support.
- Lift the stack assembly and pull it outwards from
below.
- Re-assembly will be done in the reverse order.