NEC XN120 Vision, Руководство по функциям

Страница: 137 / 222

Features
Features Manual
135
n
Operation
To program an extension’s name:
1. Press a SPK key.
2. Dial 800
OR
Press Extension Name Change key (PGM 15-07 or SC 851: 55).
3. Enter the extension number to be named.
4. Enter name (see below).
Your name can be up to 12characters maximum, try to have 8 or less to prevent the name being truncated.
5. Press HOLD.
When entering names in the procedures below, refer to this chart. Names
can be up to 12 digits long.
Use this keypad digit … When you want to …
1
Enter characters:
1 @ [ ¥ ] ^ _ ‘ { | }
2
Enter characters A-C, a-c, 2.
3 Enter characters D-F, a-f, 3.
4 Enter characters G-I, g-i, 4.
5
Enter characters J-L, j-l, 5.
6 Enter characters M-O, m-o, 6.
7
Enter characters P-S, p-s, 7.
8 Enter characters T-V, t-v, 8.
9 Enter characters W-Z, w-z, 9.
0
Enter characters:
0 ! “ # $ % & ‘ ( )
*
Enter characters:
* + , - . / : ; < = > ?
#
# = Accepts an entry (only required if two letters on
the same key are needed - ex: SR). Pressing # again
= Space.
DND/CONF
Clear the character entry one character at a time.
CLEAR
Clear all the entries from the point of the flashing
cursor and to the right.
FLASH
Change to Chinese character set. Indicated by the =
mark at the left of the name e.g.
ENTER NAME 200
=
6. Press SPK to hang up.